Symbol Technologies LS 3070 - Manual (Page 40)

5-1
Chapter 5
Interface Guide
Connecting to a Host Device
In most cases, connecting your LS 3070’s base station to your host terminal is a
very simple operation. You need only plug the cable into your host. Typical
configurations are shown on the following pages. Some POS keyboards require
more intricate installation instructions. Those begin on
page 5-6 .
We recommend that you disconnect the power supply from the base station
prior to connecting or disconnecting cables.
Refer to Interfaces beginning on page 5-23 for the proper interface cable
assembly.
After you've connected your base station to your host terminal, refer to Chapter
6: Programming for programming instructions.