Sharp Aquos LC 15L1U - Manual (Page 13)

12
F-type connector
75-ohm coaxial cable
Antenna Connection
PREPARATION (Continued)
OUTDOOR ANTENNA CONNECTION
• Use one of the following two diagrams if you connect an outdoor antenna.
A: Using a VHF/UHF combination outdoor antenna
B: Using separate VHF and/or UHF outdoor antennas
• Connect the outdoor antenna cable lead-in to ANT. (Antenna terminal) on the rear of the Wireless Center.
F-type connector
75-ohm coaxial cable (round)
300-ohm twin-lead cable (flat)
1. A 75-ohm system is generally a round cable with F-type connector that can easily be
attached to a terminal without tools (not supplied).
2. A 300-ohm system is a flat “twin-lead” cable that can be attached to a 75-ohm terminal
through a 300-75-ohm adapter (not supplied).
ANTENNAS
• The antenna requirements for good color television reception are more important than those for black & white television reception.
For this reason, a good quality outdoor antenna is strongly recommended.
The following is a brief explanation of the type of connections that are provided with the various antenna systems.
NOTICE
F-type connector should be finger-tightened only.
When conecting the RF cable to the TV set, do not tighten F-type
connector with tools.
If tools are used, it may cause damage to your TV set.
(The breaking of internal circuit, etc.)
Wireless Center
IN
OUT
AV-IN1 AV-IN1 AV-IN3
IR
OUT
POWER
INPUT DC12V
FACTORY
SERVICE
S-VIDEO
MONITOR OUT
MONITOR
OUT
VIDEO
AUDIO
L
AUDIO
R
AV-IN2
/OUT
ANT.
TV/VCR/DVD, etc.
TV
VCR
DVD
75-ohm
coaxial cable
Antenna cable
300-ohm
twin-lead
VHF/UHF
antenna
VHF/UHF
antenna
300/75-ohm
adapter
(not supplied)
300-ohm
twin-lead
300-ohm
twin-lead
75-ohm
coaxial cable
OUT IN
VHF
antenna
UHF
antenna
Combiner
(not supplied)
or
or
B: Separate VHF and/or UHF antennas
A: Combination VHF/UHF antenna