Sony KLV-40U100M - Manual (Page 42)

42
KLV-32U100M
2-668-009-13(1)
G:\#Sagyo\SONY\09 TV\kaihan KLV-
32U100M\1219_KLV32U100M_rev\2668009131\2668009131 KLV-
32U100M_US\01US07OTH.fm masterpage:3 columns Right
Other Information
Troubleshooting
Problem Possible Remedies
No picture.
No picture. ❑ Check Power Saving settings (page 41).
The unit turns off automatically. ❑ Check if Sleep Timer is activated (pages 31, 40).
No picture from some video
sources. ❑ Check the connection between the video equipment and the unit.
❑ Press V1 to V5 on the remote control (page 28) or press INPUT repeatedly
on the top panel (page 13).
Poor picture.
No color/Dark picture/The
picture is too bright/Color is not
correct ❑ Press PICTURE to select the desired Picture mode (pages 28).
❑ Adjust the Picture Mode options in the Picture settings (page 33).
Noisy picture. ❑ Keep the set-top box/VCR antenna cable away from other connecting cords.
❑ Do not use 300-ohm twin lead cables as interference may occur.
No sound/Noisy sound.
Good picture, no sound. ❑ Check the volume control.
❑ Press MUTING or VOL + so that “Muting” disappears from the screen
(page 28).
❑ Disconnect your headphones.
Audio noise. ❑ Keep the set-top box/VCR antenna cable away from other connecting cords.
Striped noise during
playback/recording of a VCR. ❑ This is caused by video head interference. Keep your VCR away from the
unit.
❑ Leave a space of 30 cm (11 7/8 inches) between your VCR and the unit to
avoid noise.
❑ Avoid installing your VCR in front of the unit or at the side of the unit.
Wide Screen Mode changes
automatically. ❑ The current Wide Screen Mode setting is automatically replaced with the
4:3 Default setting when you change the video input, if
4:3 Default in the
Screen settings is set to other than Off . If you want to lock in the Wide
Screen Mode selected with the WIDE button, set 4:3 Default to Off in the
Screen settings (page 36).
Remote control does not operate. ❑ Check the polarity of the batteries or replace the batteries.
❑ Point the remote control at the remote control sensor of the unit.
❑ Fluorescent lamps can interfere with remote control operation; try turning
off the fluorescent lamps.
❑ Keep the remote control sensor area clear from obstacles.
01US02WAR-UC.book Page 42 Monday, December 19, 2005 1:58 PM