SIGMA EF-500 - Manual (Page 27)

27
Wireless High-Speed Sync (FP Flash)
1. Please set the master flash to Wireless Flash mode. (Refer to Page 10)
2. Press the + or – button to set to 㸤
(Master Flash unit firing ON) or 㸤 (Master Flash unit firing OFF).
3. The remainder of the procedure for setting wireless high-speed sync, is the same as for normal high-speed sync.
ۋ It is not necessary to make any additional settings on the Slave units.
Wireless Flash Exposure Compensation
1. Please set master flash unit to the Wireless Flash Mode.
2. Press the SEL button to make
mark blink.
3. Press the + or – button to set the flash exposure compensation amount.
4. Press the SEL button several times to make exposure compensation indicator appear.
5. The remainder of the procedure for setting wireless Flash Exposure Compensation is the same as for
normal flash exposure compensation.
ۋ It is not necessary to make any additional setting on the Slave units.
ۋ You can also set the flash exposure compensation individually for each slave unit.
Wireless FE Lock
1. First please set the flash to Wireless Flash mode.
2. Focus on the subject and press the FEL button on the camera.
3. The procedure for setting wireless EF lock is the same as for normal FE lock.
ۋ It is not necessary to make any change to the settings on the Slave units.
Wireless Flash Exposure Bracketing (FB)
1. First please set the flash to the Wireless Flash Mode.
2. Press the SEL button several times to make the
mark blink.
3. Press the + or – button and set the flash exposure compensation amount.
4. Press the SEL button several times to make an indicator stop blinking.
5. The remainder of procedure for setting wireless FB is the same as for normal FB.
ۋ It is not necessary to change any settings on the Slave units.
Changing the Mode of Wireless
Please set the flash as follows.
1. Press the MODE button to select the ETTL / mark.
2. Press and hold the SEL button more than 2 seconds to make the mode indicator blink.
3. Press the MODE button and select the ETTL, M, or MULTI mode.
4. Press the SEL button to make the mode of indicator stop blinking.
Wireless Manual Flash
You can manually set the slave unit’s flash output, with the master unit. The flash output among the slave
units can be uniform or varied. To determine the proper flash exposure, use a hand-held flash meter.
Wireless Manual Flash With Uniform Flash Output
Please set the Master flash unit as described below.
1. Please followe the procedure of Changing the Mode of Wireless and set to the M㸤
mark.
2. Press the SEL button several times to make the flash output amount indicator blink.
3. Press the + button or – button to set the flash output amount.
4. Press the SEL button several times and the flash output will be displayed without blinking.
ۋ
If the master flash unit ON function is set, the master unit will also fire, at the same flash output.
Wireless Manual Flash With Varied Flash Output
You can set a different flash output for each slave unit(s) (Following are explains the procedure for using
with three slave flash units). Please set the master flash unit as follow.
1. Please be followed the procedure for Changing the Mode of Wireless, and set to the M㸤 mark.
2. Press the SEL button several times to make the mark blink.