Sunbeam SMW730 - Manual (Page 9)

Installation
Remove all packing material and accessories.
Examine the oven for any damage such as
dents or broken door. Do not install if oven is
damaged.
Countertop
Cabinet: Remove any protective film found
on the cabinet surface.
Do not remove the light brown Mica cover
that is screwed to the oven cavity to
protect the magnetron.
Installation
1.
Select a level surface that provide
enough open space for the intake
and/or outlet vents.
A minimum clearance of 3.0 inch
(7.5cm) is required between the oven and
any adjacent wall.One side must be open.
(3) Blocking the intake and/or outlet openings
can damage the oven.
(4) Place the oven as far away from
radios and TV as possible.Operation
of microwave oven may cause interference
to your radio or TV reception.
2.
Plug your oven into a standard household
outlet. Be sure the voltage and the
frequency is the same as the voltage and
the frequency on the rating label.
WARNING: Do not install oven over a
range cooktop or other heat-producing
appliance. If installed could be damaged
and the warranty would be void.
Hub(underside)
Glass tray
Turntable ring assembly
Turntable shaft
3.0 inch(7.5cm)
3.0 inch(7.5cm)
12 inch(30cm)
OPEN
8
TURNTABLE INSTALLATION
a. Never place the glass tray upside down.The
glass tray should never be restricted.
b. Both glass tray and turntable ring assembly must
always be used during cooking.
c. All food and containers of food are always
placed on the glass tray for cooking.
d. The glass tray rotates clockwise; this is normal.
e. If glass tray or turntable ring assemly cracks or
breaks, contact your nearest authorized
service center.
(2) Do not remove the legs from the bottom
of the oven.
(1) Leave a minimum clearance of 12inch
(30cm) above the oven.