Skuttle Indoor Air Quality Products 2000 - Manual (Page 8)

6
Tilt out the distribution tray and evaporator
pad assembly. 3.
Wash all plastic and metal parts (except electrical parts and compo-
nents) in humidifier cleaner or a 50 percent solution of vinegar and
water.
If cleaning is not sufficient, replace the evaporator pad. (See
Replacement Parts and Service, page 7.)
IMPORTANT:
The evaporator pad should be replaced at least once a year
(i.e., once each humidification season). In cases of excessive
mineral buildup, more frequent media replacement may be
necessary if cleaning is not effective.
4.
5.
•
The Humidifier­­ also contains a one-
piece wick, which must be changed
along with the evaporator pad. The
wick can be changed easily by lifting out
the old one and replacing it with the new
wick provided with the evaporator pad. •
Wipe any loose sediment from the water tray. Make sure no particles
are allowed to plug the drain hole.
IMPORTANT: At the end of each humidification season, tur­­n
the water supply off and clean the unit.
If, after cleaning or replacing the pad, your Flow­Thru Humidifier
does not perform up to previous standards, contact your HVAC
contractor for service. 6.