Woodstock ALUMA-CLASSIC W1720 - Manual (Page 12)

ADJUSTMENTS
-10-
The self-adhesive scale provides fast and accu-
rate fence positioning. It is best to install the
scale after all other adjustments in this section
have been made. Figure 15 shows the scale
properly installed on the front rail.
To install the scale indicator, do these steps:
1. UNPLUG THE TABLE SAW!
2. Raise the blade to its maximum height.
3. Position the fence against the right side of
the blade.
4. Carefully place the scale along the front
rail about 1 ⁄
2
" away from the edge and
underneath the scale indicator. Note—Do
not stretch the tape! This will cause inac-
curate cuts.
5. Position the “0” mark on the scale under
the cursor hairline and secure the scale to
the rail.
6. Adjust the cursor left or right so the hair-
line is directly over the “0” mark on the
scale.
7. Make a test cut then measure the thickness
of your test board.
8. Fine tune the hairline indicator to corre-
spond with the actual test board thickness.
This method accounts for any vibration or
wobble that may be present in the spinning
blade.
Scale Installation &
Adjustment
Figure 15. Scale installed on front rail.