Samsung CRYSTAL SURROUND AIR TRACK HT-SB1G User Manual
Page 13
1
EnG
●
c
O
nn
E
c
T
iO
n
S
cOnnEcTinG THE WiRElESS SUBWOOFER (HT-WS1G/HT-WS1R ONLY)
The Subwoofer's linking ID is preset at the factory and the main unit and sub should link (connect wirelessly)
automatically when turned on. If the link indicator does not light when main unit and subwoofer are turned on, please
set the ID by following the process below.
Before moving or installing the product, be sure to turn off the power and disconnect the power
cord.
If the main unit is powered off, the wireless subwoofer will be in the standby mode and the
STANDBY LED on the upper side will blink.
If you use a device such as a microwave oven, wireless LAN Card, Bluetooth equipment, or
any other device that uses the same frequency (2.4GHz) near the system, some sound
interruption may be heard due to interference.
The transmission distance of the wireless signal between the main unit and sub is about 32
feet, but may vary depending on your operating environment. If a steel-concrete
or metallic wall is between main unit and the wireless subwoofer, the system may not
operate at all, because the wireless signal cannot penetrate metal.
If the main unit doesn't make wireless connection, follow steps 1-4 above to retry the
connection between the main unit and wireless subwoofer.
The wireless receiving antenna is built into the wireless subwoofer. Keep the unit away
from water and moisture.
For optimal listening performance, make sure that the area around the wireless subwoofer
location is clear of any obstructions.
▪
▪
▪
▪
▪
▪
▪
1. Plug the power codes of the main unit and subwoofer into the AC power supply.
. Press the ID SET button on the back of the subwoofer with a small pointed object for 3 seconds.
The STANDBY indicator is turned off and the LINK indicator (blue LED) blinks quickly.
•
. While main unit is powered off (STANDBY mode), press MUTE on the
remote control for 5 seconds.
The volume Level Indicator on the main unit lights up, then returns to
STANDBY mode.
. Press the POWER button to turn on the main unit.
The main unit and the subwoofer are now linked (connected).
The Link indicator (blue LED) on the subwoofer is turned on.
You can enjoy better sound from the wireless subwoofer by selecting the
sound field mode. ( See page 16 )
•
•
•
•
POWER
TV POWER
TV SOURCE
VOL
TV CH
PASS
NEWS
MUSIC
MUTE
CINEMA
O/A
INPUT
POWER
LINK
AUTO
MENU
EXIT
TOOLS
INFO
POWER
TV POWER
TV SOURCE
VOL
TV CH
PASS
NEWS
MUSIC
MUTE
CINEMA
O/A
INPUT
POWER
LINK
AUTO
MENU
EXIT
TOOLS
INFO