Southbend SB1020 - Manual (Page 32)

-30-
For Machines Mfg. Since 8/09 Model SB1020 O P E R A T I O N
Operation Tips
Review the following tips to help you safely and
effectively operate your bandsaw and get the
maximum life out of your saw blades.
• Use the work stop to quickly and accurately
cut multiple pieces of stock to the same
length.
• Let the blade reach full speed before
engaging the workpiece. Never start a cut
with the blade in contact with the workpiece.
• Pay attention to the chips produced by the
cutting operation and use their appearance
to fine-tune the blade speed, feed speed,
and pressure (refer to the Chip Inspection
Chart on Page 26).
• Wait until the blade has completely stopped
before removing the workpiece from the vise,
and avoid touching the cut end—it could be
very hot!
Release blade tension at the end of each use
to prolong blade life.
4. Adjust the valves on the coolant hoses to
control the flow of coolant (see Figure 35).
Make sure that the pressure is not so high
that coolant spills on the floor and creates a
slipping hazard.
Figure 35. Coolant control valve.
NOTICE
Keep the tray chip screen clear so coolant can
recycle to the pump reservoir. NEVER operate
the pump with the reservoir below the low
mark or you may over-heat the pump and void
your warranty!
Coolant Control Valves