Samsung iDCS 100 - Manual (Page 80)

13
INTERCOM CALLS
CALLING OTHER STATIONS
• Dial the extension number or group number.
• Wait for the party to answer. If you hear a brief tone burst instead of ring-
back tone, the station you called is set for Voice Announce or Auto
Answer. Begin speaking immediately after the tone.
• Finish the call by replacing the handset or pressing the ANS/RLS or the
MONITOR key if you are using a 7B phone.
NOTES:
1.
If you have a DSS key assigned to an extension or station group, you
may press this key instead of dialing the number. If you are using a 7
Button Set you must pick up the handset to speak to the calling party.
2. If the Hot Keypad feature has been turned off, you must first lift the hand-
set or press the SPK or the MONITOR key if you are using a 7B phone
before you begin dialing.
ANSWERING INTERCOM CALLS
• When your keyset rings, simply lift the handset—OR—press the
ANS/RLS key to be connected to the calling station. If you are using a
7B phone you must pick up the handset to speak to the calling party.
• Finish the call by replacing the handset or pressing the ANS/RLS or the
MONITOR key if you are using a 7B phone.
See Ring Preference under Customizing Your Keyset.
VOICE ANNOUNCE MODE
(INTERCOM CALLS ONLY)
When another station calls you, your keyset will sound a brief attention tone
and you will hear the caller’s announcement.
• Press ANS/RLS to turn on the microphone and speak handsfree—OR—
lift the handset to reply.
• To finish the call, replace the handset or press the ANS/RLS key.
• While you are listening to confirmation tone, press the HOLD key. This
will cancel the oldest set callback.
NOTES:
1.
If the hot keypad feature is turned off, you must first lift the handset or
press the SPK or the MONITOR key if you are using a 7B phone before
dialing.
12
HOME PAGE Table of Contents Guide-Contents