Woodstock SHOP FOX W1755 - Manual (Page 19)

-17-
W1755 6" Parallelogram Jointer
SE
TU
P
29. Test that the cutterhead guard is working correctly
by pulling it back and letting go. The cutterhead
guard should quickly spring back over the cutterhead
when you do this.
— If the guard does not quickly spring back over
the cutterhead when you perform this test, then
remove it and repeat Steps 27–29. Do not con-
tinue with the assembly until the cutterhead guard
works correctly.
30. Use the two M10-1.5 x 25 cap screws, 10mm lock
washers, and 10mm flat washers to attach the ped-
estal switch to the back of the jointer, as shown in
Figure 23, then connect it to the motor cord.
31. Use the four M5-.8 x 16 Phillips head screws and
5mm flat washers to install the dust port on the
jointer stand, as shown in Figure 24.
Figure 23. Attaching pedestal switch to
the back of the jointer.
Figure 22. Securing the cutterhead guard.
Set Screw
Figure 24. Attaching dust port to jointer
stand.
Figure 25. Knife setting jig assembly.
DO NOT operate the Model W1755 without an ade-
quate dust collection system. This machine creates
substantial amounts of wood dust while operating.
Failure to use a dust collection system can result in
short and long-term respiratory illness.
Assemble the knife setting jig as shown in Figure 25.
Knife Setting Jig
Recommended CFM at Dust Port: ................ 400 CFM
Do not confuse this CFM recommendation with the rating
of the dust collector. To determine the CFM at the dust
port, you must take into account many variables, includ-
ing the CFM rating of the dust collector, the length of
hose between the dust collector and the machine, the
amount of branches or Y's, and the amount of other open
lines throughout the system. Explaining this calculation
is beyond the scope of this manual. If you are unsure of
your system, consult an expert or purchase a good dust
collection "how-to" book.
Dust Collection