Sprint Nextel 2.4 GHz Digital Spread Spectrum Dual Keypad Cordless Phone with Caller ID/Call Waiting - Manual (Page 9)

9 Installation
On a Wall Plate or Wall
1. Insert the bracket’s tabs into the base’s
lower tab slots, then press down on the
bracket’s clips and insert them into the
clip slots.
2. Plug one end of the supplied short mod-
ular cord into the TEL LINE jack on the
back of the base.
3. Insert the supplied AC adapter's barrel
plug into DC IN 9V jack on the back of the
base.
4. Route the adapter and modular cords
through the grooves on the bracket.
5. Plug the modular
cord's other end
into the wall plate
jack, then align the
bracket's keyhole
slots with the wall
plate studs and
slide the base downward to secure it.
6. Plug the adapter into a standard AC out-
let.
7. Press and lift out the handset holder.
Rotate it 180°, then snap it back into
place so it holds the handset.
8. Lift the base's antenna to a vertical posi-
tion.
Note: To mount the phone directly on a wall,
you need two screws (not supplied) with
heads that fit into the keyhole slots on the
bottom of the base (minimum length 1
3 / 8
inches.
Follow the steps under “On a Wall Plate or
Wall,” then apply these additional instruc-
tions for placement on a wall.
1. Drill two holes 3
15
/ 16
inches (100 mm) apart.
Then thread a screw into
each hole, letting the
heads extend about
3 /
16
inch (5 mm) from the wall.
2. Plug one end of the sup-
plied long modular cord
into the
TEL LINE jack on the back of the
base and route the adapter cable and
modular cords through the grooves on
the bracket.
3. Align the bracket's keyhole slots with the
mounting screws and slide the base
downward to secure it.
CONNECTING, CHARGING
AND REPLACING THE
BATTERY PACK
The phone comes with a rechargeable
nickel-cadmium battery pack in the hand-
set. Before using your phone, you must
connect the battery pack, then charge it for
about 24 hours.
3 15 /
16
"
3 /
16
"
43-5522.fm Page 9 Tuesday, September 12, 2000 3:12 PM