Silvercrest KH 2450 - Manual (Page 12)

14
Ú in battery/cell operation, the battery symbol ; the beams in the battery
symbol indicate the current full resp. charged condition of the batteries.
Ú in mains power/USB operation the symbol .
The voice recorder is now ready for use.
7. using the voice recorder
7.1 Switching the voice recorder on
1
To switch the voice recorder on: Press the button »ON/OFF«
a
once. The sta-
tus lamp »DICT «
d
briefly lights up once. In the display
q
the SilverCrest
logo is briefly shown; indicated subsequently are:
Ú should the batteries/cells have been exchanged before switching on: the battery
selection screen (see chapter 6 »Preparing the voice recorder for use«, step 3);
the battery selection screen is not indicated if …
Ú the batteries/cells were not exchanged before switching on
Ú the switched-off voice recorder is connected to a PC via a USB cable
(PC operation)
Ú subsequently the SilverCrest logo
Ú »INT«, should there not be a memory card inserted into the memory card slot
o
; in this case the internal memory of the voice recorder is used for dicta-
tions.
Ú »EXT«, should there be an SD/MMC memory card inserted into the memory
card slot
o
; in this case the memory card is used exclusively as an external
memory for dictation recording.
During software loading phases the hourglass symbol in blended in briefly.
Consequently, a short signal tone sounds and the start screen appears with the
following indicators/menu choices:
Should it be that no dictations have yet been saved:
Bedienungsanleitung KH 2450 EN.indd 14 23.12.2008 23:09:40