Samsung 521 - Manual (Page 9)

9
ENG
Video Connections (cont.)
1 Connect an optional AUDIO/VIDEO cable from the VIDEO OUT jack on the rear of the VCR to the VIDEO IN jack on
the rear of the TV.
2 Connect another optional audio/video cable from the AUDIO OUT jacks on the rear of the VCR to the AUDIO IN jacks
on the rear of the TV.
◆ If you have a VCR with 21 pin scart jack, connect scart cable to the rear of TV (Option).
3 Press the TV/VIDEO button to select “AV”.
◆ As you press the button, TV, AV1, AV2, AV3, S-VIDEO1, and S-VIDEO2 are repeated alternately.
TV ➞ S-VIDEO1 ➞ S-VIDEO2 ➞ AV1 ➞ AV2 ➞ AV3
if connected
4 Playback a tape in the VCR.
(See owner’s Manual for VCR)
☛
Self Checkup Function
◆ When all front and rear jack of this TV are disconnected, the video mode changes as
below.
TV ➞ AV3
(When only AV1 Jack is connected)
TV ➞ AV1
☛
TV/Video Selection
◆ Press the TV/VIDEO button repeatedly to select the desired input.
◆ Whenever the TV/VIDEO button is pressed, the mode changes as below.
TV ➞ S-VIDEO1 ➞ S-VIDEO2
AV3 AV2 AV1
(when all input jacks are connected)
➣
◆ When video mode is selected and that AV mode has no input picture signal, the
background colour of the TV screen will change to blue regardless of whether the BLUE-
SCREEN function is set.
◆ Teletext displays on screen will not be output at the Monitor output terminal and Scart
output terminal.
◆ AV mode isn’t selected when VCR wasn’t operating, so you must check VCR status before
selecting AV mode.
➞
➞
➞
➞ ➞
➞
11318A#2 8/17/05 12:42 PM Page 9