Woodstock 18 GAUGE STAPLER KIT W1779 - Manual (Page 12)

Model W1779 18 Gauge Stapler Kit
-10-
A jammed staple must be cleared before
using the stapler again.
To clear a jammed staple from the
discharge area, do these steps:
1. DISCONNECT STAPLER FROM THE AIR
SUPPLY!
2. Pull back and latch the magazine.
3. Remove the staple stick from the
magazine.
4. Loosen the cap screws shown in
Figure 8, and remove the nose cover.
Clearing Jammed
Staples
Figure 8. Loosening cap screws on cover.
5. Remove the jammed staple with
needle nose pliers.
6. Secure the safety cover with the cap
screws removed in Step 4.
7. Throw the damaged staple away.
8. Inspect the staple stick. If it is bent
or damaged, insert a new staple stick
that only contains clean, undamaged
staples. DO NOT use dirty or damaged
staples!
9. Latch the magazine closed.
To operate your stapler in bump fire
mode, do these steps:
1. Push the trigger switch IN (Figure 7).
Nose Cover
Cap Screw
Figure 7. Trigger switch, bump fire
mode.
2. Pull and hold down the trigger.
3. Press the safety mechanism against
your workpiece and raise it after the
staple is driven.
4. Continue holding the trigger and
repeat Step 3 to drive more staples.