Sony Ericsson K300a User Manual
Page 9
7
This is the internet version of the user’s guide. © Print only for private use.
1
Slide the cover open and lift it off.
2
Insert the SIM card. Make sure the SIM card is placed
under the silvery holders.
3
Place the battery in the phone with the label side up and
the connectors facing each other.
4
Place the cover on the phone and slide it into place.
5
Connect the charger to the phone at the flash symbol.
The flash symbol on the charger plug must face
upwards.
6
It may take 30 minutes for the battery icon to appear.
7
Wait approximately 4 hours or until the battery icon
indicates that the battery is fully charged. For an
indication of charging, press
to activate the screen.
8
Remove the charger by tilting the plug upwards.
PIN (Personal Identification Number)
You may need a PIN (Personal Identification Number) from
your network operator to activate the services in your phone.
Each PIN digit appears as *, unless it starts with emergency
number digits, for example 911 or 112. This is so that you can
Some functions use more battery power than others
and may cause a need for more frequent re-charging.
However talk-time or standby time may become
noticeably shorter due to wear and you may have to
replace your battery. Only use approved batteries from
Sony Ericsson
UG.book Page 7 Tuesday, March 22, 2005 2:16 PM