Sharp Z-336J - Manual (Page 129)

10-5
Chapter 10: Communication Control
10
[4] Local node management table
This section shows the information about the local node as part of the network control information.
*1: Addresses +140 to 223
(8)
are offset addresses calculated from the top address that is stored in the
parameter at addresses 30 to 32
(8)
.
FA link layer status (LKS)
Shows the FA link status of the network.
Upper layer status (ULS)
Show the upper layer status using RUN/STOP (1 bit), UERR (2 bits), and UERR CODE (12
bits).
Address (8) Details
Corresponding
header information
+140 Node number
+141 Reserved area
+142 to 153 Node name (facility name)
+154 to 165 Vendor name
+166 to 177 Manufacturer's model name
+200 This node's status
+201 Reserved area
+202 FA link layer status => See below LKS
+203 Reserved area
+204 to 205 Status of the upper layer => See below ULS
+206 to 207 Common memory (area 1) storage address C_AD1
+210 to 211 Common memory (area 1) storage size C_SZ1
+212 to 213 Common memory (area 2) storage address C_AD2
+214 to 215 Common memory (area 2) storage size C_SZ2
+216 Token monitor time-out time TW
+217 Reserved area
+220 Minimum allowable time between frames MFT
+221 Reserved area
+222 Protocol version PVER
+223 Reserved area
7 6 5 4 3 2 1 0
Spare
Bit
Upper layer operation signal error
Notice to be effective common memory data
Complete common memory settings (address size)
Detected duplicate use of the same address
Base address +202
Reserved bit
U ERR
U ERR CODE
(Upper layer error code:
Defined by the upper layer)
+204
00 NORMAL
01 WARNING
10 ALARM
11 ALARM
0 STOP
1 RUN
7 6 5 4 3 2 1 0 7 6 5 4 3 2 1 0 Bit
Base address +205