Sharp Z-336J - Manual (Page 84)

9-7
Chapter 9: Message transfers
9
(3) For the JW50H/70H/100H
* 1300 to 1477 (file addresses 001300 to 001477) are for shared use with the general-purpose
relays. Therefore, if a timer/counter is set up with 1024 points, these file addresses cannot be used
as general-purpose relays.
- The relationship between the PC model (on which the memory module is installed) and the file
memory is as follows.
Note: Be careful not to allow the transmission buffer area to overlap with the common memory area.
Allocation available data memory address for common memory area
Bit address (8) Byte address (8) File address (8)
File 0
Relay 00000 to 15777 0000 to 1577 000000 to 001577
TMR/CNT
contact
point
T-C0000 to 0777 1600 to 1777 001600 to 001777
T-C1000 to 1777 1300 to 1477 * 001300 to 001477 *
TMR/CNT-
/MD
current
value
--- b0000 to b1777 002000 to 003777
Register ---
09000 to 09777 004000 to 004777
19000 to 19777 005000 to 005777
29000 to 29777 006000 to 006777
39000 to 39777 007000 to 007777
49000 to 49777 010000 to 010777
59000 to 59777 011000 to 011777
69000 to 69777 012000 to 012777
79000 to 79777 013000 to 013777
89000 to 89777 014000 to 014777
99000 to 99777 015000 to 015777
E0000 to E0777 016000 to 016777
E1000 to E1777 017000 to 017777
File 1 --- --- 000000 to 177777
File 2 --- --- 000000 to 177777
File 3 --- --- 000000 to 177777
to to to to
File 7 --- --- 000000 to 177777
PC model Integrated memory module File memory
JW50H --- File 0, 1 (000000 to 037777)
JW70H
JW100H
JW-1MAH File 0, 1 (000000 to 037777)
JW-2MAH File 0, 1 (000000 to 177777)
JW-3MAH File 0, 1, 2
JW-4MAH File 1 to 7