Subaru LEGACY H7110LS200 User Manual
Page 2
2
Figure 1
Figure 2
Figure 3
A. Pre-Installation Notes
B. Security Module Installation
1. Vehicle Preparation
a. Lower the driver’s side window to avoid inadvertently locking the keys in the vehicle dur-
ing installation.
b. Disconnect negative battery terminal to prevent accidental shorting of any power circuits.
2. System Preparation
Remove the security module from the package and inspect for any physical damage.
3. Shock Sensor Adjustment
The shock sensor adjustment knob is recessed inside the unit and is covered by a protective
seal.
This adjustment is PRESET at the factory.
1. Remove the gearshift cover by pulling up in areas
indicated by arrows in Figure 1.
a. For automatic transmission, shifter must tem-
porarily be placed into neutral.
b. For standard transmission, the shift knob must
be removed by unscrewing.
2. Remove the tray by removing the two screws indi-
cated by arrows in Figure 2.
3. Remove the ashtray. Disassemble ashtray assembly
by removing the two screws indicated by arrows in
Figure 3.
39412/SUBARU (P.01-09) 8/1/00 5:39 PM Page 2