Samsung SVD-4700 - Manual (Page 6)

COLOR DOME CAMERA User Guide 10 COLOR DOME CAMERA User Guide 11
Installation
Installation
Adjust the panning, tilting and rotate mechanism while checking the position on the monitor
1. Remove the dome cover and inner cover from the main body by loosening the three
dome cover screws.
2. And then remove the main body from the mounting bracket by the four main body screws.
Mounting Bracket
Main Body(Camera)
Dome Cover
Inner Cover
73°
-170°
145° 195°
170°
Pan Base
Tilt Base
Rotate Base
•Theinstallationshouldbedonebyqualifiedservicepersonnelorsysteminstallers.
•Iftheceilingmaterialisnotstrongenoughtoholdtheinstallationscrews,thecamera
mayfalloff.Reinforcetheceilingasneeded.
•Takecarenottodroptheproductduringinstallation.Donotallowanyonetostand
belowtheinstallationarea.
Notes
 You can adjust camera to any direction by using the Pan, Tilt, Rotate mechanism.
• Pan Base moves by 170° in each direction or 340° in total.
• Tilt Base covers 73° in each direction or 146° in total.
• The angle range of the Rotate Base is the same as that of the Pan Base.But one
direction range is 195° and another is 145°
 Methods of adjustment
• Wall installation
 …After mounting the camera to the wall, loosen the rotate base holding screws.
 …Adjust to the correct panning angle.
 …Then adjust the tilt angle by rotating the base.
 …Once complete re-tighten the rotate base holding screws.
• Ceiling installation
 …After mounting the camera to the ceiling, loosen the rotate base holding screws.
 …Adjust to the correct panning angle.
 …Then adjust the tilt angle by rotating the base.
 …Once complete re-tighten the rotate base holding screws.
•Whenadjustingtherotatingangle,loosenrotatebaseholdingscrewasfollowsFigures.
Thentightenitagain.
•Whenadjustingthetiltingangle,gripthetiltbaseandadjusttiltingangle.
•Whenadjustingthepanningangle,loosenpanbaseholdingscrewsasshownbelow
andthenre-tighten.
Notes
•WhenadjustingthetiltmechanismholdtheTiltbaseandNOTthelens.
RotateBaseHoldingScrew
PanBaseHoldingScrew RotateBaseHoldingScrew