Sierra 5391-02 - Manual (Page 30)

T12017-Sentry_LANServer_Users_Manual Page 30 of 59
FieldServer Technologies 1991 Tarob Court Milpitas, California 95035 USA Web:www.fieldserver.com
Tel: (408) 262-2299 Fax: (408) 262-2269 Toll_Free: 888-509-1970 email: [email protected]
Lower Display
The information displayed in this section is the same as displayed on the Lower Display on
the front of the Sentry controller. Normally the current Sensor’s name and Engineering units
are displayed here. If a ‘Time Out’ message is displayed then this means that the Faceplate
has not obtained data from the LANServer. Other error messages may also be displayed
here.
Visual Sensor Alarm Indicators
Normal: Solid Green
Warning: Solid Red
Alarm: Flashing Red/White
Key Pad Zone
The response time to the Key Pad is very slow and it is recommended if possible to perform
any activity requiring the Key Pad at the Sentry Controller and not via the LANServer. It is
recommended that the user wait for up to 30 seconds before trying another key. Pushing
keys here is just the same as pushing keys on the front pad of the actual Sentry. Refer to
the Sentry Instruction Manual for information on the Key Pad actions.
Status LED’s
The LANServer Sentry Faceplate includes the LEDs indicating Power On, Trouble, and
whether the system is in Calibrate/Change mode as on the controller. Refer to Sentry
Instruction Manual for details on these LEDs.
Sensor 1
Sensor 8