Samsung SCC-3000 - Manual (Page 24)

《24》
PTZ Mode
(9) OSD
■ This is used for displaying the camera menu on the monitor.
① At the initial screen, press the OSD button.
② Use the controller buttons to set up the camera menu.
- OSD : SPD 1600/2200/2500 - Toggle camera menu on/off (hold down for 2
seconds)
PELCO-D - Toggle camera menu on/off (press ESC)
PANASONIC (WV-CS854A) - Toggle camera menu on/off (press ESC)
Samsung (SCC-643/641) - Toggle camera menu on/off (press ESC)
- ESC : Cancels the menu selection.
- ENTER : Selects the menu.
- ▶▶ : Moves the menu cursor right.
- I ▶ : Moves the menu cursor left.
- II : Moves the menu cursor up.
- ■ : Moves the menu cursor down.
- Joystick : Use the joystick to move the menu cursor up, down, left, and
right.(Applies to SPD, PELCO-D and Samsung models only:)
▤ Joystick or other button inputs cannot be used for camera operation when the
camera menu is displayed on the monitor.
▤ PRESET, SWING, GROUP, and TRACE functions can be set in the OSD menu
of the camera.
▤ Please refer to the camera manual for more information on the camera menu.
▤ When operating the PTZ camera OSD menu while the controller and SVR-1630
are connected, the ENTER and ESC functions can only be performed by the
FOCUS -/+ button.
Applies to PANASONIC models only