Woodstock W1814 - Manual (Page 32)

-30-
N(/(+Fne\i jDXelXc D]^%('&'/"
J<I
M
@:<
M$9\ckI\gcXZ\d\ek
Your W1814 uses belts to drive both the cutterhead and
the dust collection impeller. When these belts are not
tensioned correctly, misaligned, or damaged, your jointer
will not function properly.
The part number for the replacement drive belt is
#X1814170; the part number for the replacement impeller
belt is #X1814192.
Refer to the parts diagram in this manual when fixing
belt problems. If you need further assistance, call our
Tech Support at (360) 734-3482 or send e-mail to:
k\Z_$
jlggfik7j_fg]fo%Y`q.
Kfi\Xc`^efii\gcXZ\k_\Zlkk\i_\X[Y\ck#[fk_\j\
jk\gj1
(% DISCONNECT JOINTER FROM POWER SOURCE.
)% While facing the rear of the jointer, tip it away from
you until it rests on the fence assembly.
*% Remove the screws that hold the motor cover to the
jointer base. Lift the cover off and set it aside.
+% Vacuum all dust and debris from the motor and belt
areas.
,% Inspect the cutterhead belt for proper tension,
straight alignment, and possible damage or wear.
Efk\1K_\Y\ck`jgifg\icpk\ej`fe\[`]`k[\]c\Zkj
XYflk
* Ð
+
n_\epflgi\jj[fnefed`[[c\f]k_\
Y\ckn`k_df[\iXk\gi\jjli\]ifdpflik_ldYfi
]fi\]`e^\i%K_\Y\ck`jgifg\icpXc`^e\[`]`kc`\j]cXk
Xe[jkiX`^_kfek_\dfkfij_X]kXe[[i`m\glcc\p%
9\ck[XdX^\n`ccY\\m`[\ekfe`ejg\Zk`fe%
-% Loosen the four motor mounting cap screws (see
=`^li\+-), but do not remove them.
.% Replace a damaged belt with a new one. Realign and
re-tension the belt.
/% Tighten the motor mounting screws and replace the
motor cover.
0% Test run the jointer. Repeat this procedure if
necessary. If repeating this procedure does not solve
the problem, call our Tech Support.
=`^li\46. Motor mounting screws and
belt locations.
Kfi\gcXZ\k_\]XeY\ck#[fk_\j\jk\gj1
(% DISCONNECT JOINTER FROM POWER
SOURCE.
)% Remove the motor cover, set it aside
and check the belt for damage.
 Efk\1 @k`j_`^_cplec`b\cpk_Xkk_`j
Y\ckn`cc\m\iY\d`jXc`^e\[fiflkf]
k\ej`fe%@]`k`j#k_\af`ek\ie\\[jkf
Y\j\im`Z\[YpXhlXc`]`\[k\Z_e`Z`Xe%
:XccfliK\Z_Jlggfik%
*% If the belt is damaged, put one end of
the new belt on the fan pulley, then
fit the other end onto the drive pulley.
+% Replace the motor cover and secure it
with the screws.
Cutterhead Belt
Motor Mount Screws
Fan Belt