Woodstock SHOP FOX W2006 - Manual (Page 12)

-10- Shop Fox ® Classic Fence
DO NOT operate the saw without a blade guard
installed. Operating without a guard creates a
risk of injury from kickback or flying debris. If
you encounter any difficulty with reinstalling
the blade guard with the new fence system,
contact Woodstock’s Technical Support.
Figure 8. Rail and guard bracket installation.
Blade Guard
The SHOP FOX ® Classic Fence is intended
to work with all table saw blade guards.
After installing the rear rail you will be
able to reinstall the guard assembly without
interference with the rail. A typical installation
is shown below in
Figure 8.
If you have any questions or concerns about the
blade guard on your saw working in conjunction
with the new fence, please see your dealer or
contact Woodstock’s Technical Support.
Magnetic Switch
At the left hand edge of the front rail there are
pre-drilled holes which can be used to mount
the table saw ON/OFF switch to the rail. This
relocation of the magnetic switch makes it easy
to turn the saw on and off without reaching
underneath the table. Consult the instruction
manual for your saw table to determine
whether it is possible to locate your switch on
the rail. Mount the switch to the rail using the
1 ⁄
4
-20 X 3 ⁄
4
" flat head screws, 1 ⁄
4
-20 hex nuts,
and 1 ⁄
4
" flat washers.
Always make certain the saw is disconnected
from the power supply before opening the
switch box.