Sterling Plumbing Dual-Flush Close-Coupled Toilet 402027 - Manual (Page 4)

2. Install the Bowl
Install a supply shut-off valve.
Lay the toilet down onto a padded surface.
From the bottom of the toilet, firmly press a new wax seal around
the toilet outlet.
Remove the temporary rag (if used) from the toilet flange hole.
Align and lower the toilet over the flange and T-bolts.
IMPORTANT! Risk of external leakage. Do not lift or rock the bowl
after placement. If you break the watertight seal, you must install a
new wax seal.
Apply your full body weight around the toilet to set the seal.
Place the bolt cap bases over the T-bolts in the ″up″ position as
marked.
Place the washers and nuts on the bolt cap bases and T-bolts.
IMPORTANT! Risk of product damage. Overtightening may cause
breakage or chipping of the vitreous china.
Carefully tighten the nuts.
IMPORTANT! Risk of product damage. Protect the vitreous china
from the saw blade when cutting off excess T-bolt length.
Measure the length of the T-bolts from the top of the nuts. If the
bolts extend 1/4
″ (6 mm) or more, cut off the excess.
Attach the bolt caps.
Nut
Washer
Bolt Cap Base
Bolt Cap
T-Bolt
Wax Seal
Closet Flange
T-Bolt
1035429-2-D 4 Sterling