Shark BG-2820 - Manual (Page 6)

97-707 • Bg • reV. /07
OPERA
TOR’S MANU
AL
PRESSURE
W
ASHER
6
STep 1: attach the handle to the
frame of the pressure washer.
Note:
it may be necessary to move the
handle supports from side to side
in order to align the handle so it will
slide over the frame supports.
STep 2: insert the carriage bolt
through the holes from the outside
of the unit and attach a nut from
the inside of the machine. tighten
nuts. STep 3: attach the spray gun/hose
storage handle, and bracket to
handle. tighten nuts.
STep 4: attach the high pressure
hose to the spray gun using teflon
tape on hose threads. STep 6: release the coupler collar
and push the nozzle until the collar
clicks. pull the nozzle to make sure
it is seated properly.
STep 7: connect high pressure
hose to pumps discharge nipple.
push coupler collar forward until
secure.
STep 5: pull the spring-loaded
collar of the wand coupler back
to insert your choice of pressure
nozzle.
STep 8: connect garden hose to
the cold water source.
aSSeMBly INSTRUCTIoNS
STep 9: connect the garden hose to pump water inlet.
inspect inlets.
CAUTION: Do not run the pump with-
out water or pump damage will result.
alignment
holes
handle
frame
assy.
Carriage
Bolt
Nut
Studs
Nut
hose/Spray Gun
Storage Bracket
Safety
latch
Spray
Gun
high pressure
hose
Wand
Coupler
pressure
Nozzle
pressure
Nozzle
Wand Coupler
Wand Collar
discharge
Nipple
high pressure hose Cold
Water
Source
Garden
hose
pump
Water Inlet
Garden
hose
Coupler
Collar
Bolts
Washer