Stamina Products fusion 15-4545 - Manual (Page 11)

11
SET UP INSTRUCTIONS
Place the Magnetic Fusion 4545 Bike in the area where it will be used. It is recommended that the Magnetic
Fusion 4545 Bike be placed on an equipment mat. The Magnetic Fusion 4545 Bike is approximately 57 3/4
inches long x 24 3/8 inches wide x 43 3/4 inches tall (max.). (These dimensions may vary up to one inch.)
An area 4 feet wide x 7 feet long is required for safe operation of the Magnetic Fusion 4545 Bike. Make
sure that adequate space is available for access to and passage around the Magnetic Fusion 4545 Bike.
Adjust the STAND(54) under the FRONT FRAME(1) and the LEVELING CAPS(53) on the
REAR STABILIZER(4) so that the Bike sits on the floor without rocking. Remove and reposition
the LEVELING CAPS(53) on the REAR STABILIZER(4) to level the Magnetic Fusion 4545
Bike.
The Magnetic Fusion 4545 Bike has a pair of WHEELS(52) on the FRONT STABILIZER (2).
Lift up from REAR STABILIZER(4) to move the Magnetic Fusion 4545 Bike. LEVELING:
MOVING:
To level the Magnetic Fusion 4545 Bike, first screw the STAND(54) located in the middle of the FRONT
FRAME(1) all the way up into the FRONT FRAME(1) so that it is not touching the floor.
Adjust the two
LEVELING CAPS(53) on the REAR STABILIZER(4). When the LEVELING CAPS(53) are adjusted and
the
Magnetic Fusion 4545 Bike is stable, rotate the STAND(54) to make it contact with the floor.
While you are adjusting the LEVELING CAPS(53) the STAND(54) must not be in contact with the floor.
Only after the
Magnetic Fusion 4545 Bike has been stabilized with the LEVELING CAPS(53) will you
position the STAND(54) so it is in contact with the floor to provide extra stability for the frame.
EQUIPMENT MAT (not included)
Down Button(43)
Up Button(42)
FUNCTION INSPECTION:
Visually inspect the Magnetic Fusion 4545 Bike to verify that assembly is as shown in the above illustration.
Check the function of the Magnetic Fusion 4545 Bike by turning the crank slowly through one complete
revolution to verify that the drive train functions properly. Press the UP and DOWN BUTTONS(42, 43) on
the ends of the HANDRAILS(6) to verify that the adjustable tension is working properly.
Locate and read the WARNING LABEL(85) on the Magnetic Fusion 4545 Bike. Make sure
that all users read the WARNING LABEL(85). CAUTION: