Samsung NETWORK DIGITAL VIDEO RECORDER - Manual (Page 14)

9
CHAPTER 4
OPERATION PROCEDURES
1 Getting Started with your machine
Please assure the following instructions before you switch on the machine:
1.1 Voltage check: Before power cable is connected, please check the voltage of this appliance
against the supply.
Input voltage range 90~260V, frequency range 57-63Hz.
CAUTION - Damage would be caused if incorrect power voltage applied.
1.2 Hard Disk connection: Make sure the 40-Pin Hard Disk Data cable and the 4-Pin power
connectors are properly connected.
2 Recording
Press the REC key to enter the Recording Mode. And press the STOP key to stop recording.
z “REC[M]” or “REC[Q]” sign will be indicated in top left corner on the screen, It mean you
select MUX or QUAD recording.
z “15P” sign will be indicated in top right corner on the screen, It mean the recording speed you
selected. 15P means 15 fields per second.
z “O” sign will be indicated in center corner on the screen, It mean the marked channel be
recorded.
™ For more information on Setting up Recording Mode, refer to Chapter 3 Record Setup
™ In Recording Mode, if there is a power failure or power lost for any reasons that cause a shut down
of this machine, it will be back to the Recording Mode automatically when power restored.
3 Playback
Press the ►PLAY button to into time search.
The following message will be displayed on the screen (The list of MASTER HARD DRIVE means
the time it start and end be recorded at this HDD).
TIME SEARCH
> MASTER HARD DRIVE
2004/JUN/30 10:12:03
START TIME 2004/JUN/30 08:16:55
END TIME 2004/JUL/09 12:09:09
Use the ◄ or ► button to select items.
Press the ▲ or ▼ button to decrease /
increase the number.
Press MENU to escape to exit the set
up mode.
Press ►PLAY button to play video forward.
z “PLAY” sign will be indicated in top left corner on the screen.
z “MUX or QUAD” sign will be indicated in top right corner on the screen, It mean the recording
mode you selected.
Press Rew Search button to play video reverse at 6 times speed fast rewind mode.
Press F.Fwd Search button to play video forward at high speed. Press the button again the
speed will be change circulative from 2, 4, to the highest 6.