Smeg PS906 - Manual (Page 9)

30
Instructions for the installer
8. INSTALLING THE APPLIANCE
8.1 Positioning in the counter top
This is a class 3 appliance.
The following operation requires building and/or carpentry work, therefore
it must be carried out by a skilled technician.
Installation can be carried out on various materials such as masonry,
metal, solid wood or plastic laminated wood as long as they are heat
resistant (T 90°C).
8.1.1
Fixing to the supporting structure
Create an opening in the counter top
with the dimensions shown in the
figure, keeping a minimum distance of
50 mm from the rear edge. This
appliance can be mounted against
walls higher than the work surface on
condition that a distance of "X" be
kept between the appliance and the
wall as shown in the figure so as to
avoid damage from overheating.
Make sure that there is a minimum of 750 mm (Fig1) between the hob and
any shelf that may be installed directly above it.
Carefully position the supplied
insulating seal (E) on the outer
perimeter of the hole made in
the counter top, trying to make
it stick on the entire surface by
applying light pressure on it
with your hands. Once the hob
is fixed in position remove
excess material using a cutter.