Stamina Products 35-1655E - Manual (Page 11)

STEP 5: Refer to illustration Step 5. Set the position of the SECURE PIN(10) as shown. Lift up the RAILS
(1, 2), insert the SECURE PIN(10) into the RAIL(1), and hook the Wire Ring onto the pin from the bottom of
the RAIL(1).
STEP 6: Fold the trampoline again as shown in illustration Step 6.
Wire Ring
STEP 4: To prevent the trampoline from snapping into the folded position, push down the four RAILS(1,2,3,4).
Then unhook the Wire Ring from the SECURE PIN(10) and turn the pin to a flat position to remove the pin.
Firmly grasp both sides of the trampoline and fold the trampoline upward, the trampoline will fold upward at
the BRACKET GUIDES as shown in illustration Step 4.
STEP 3: Remove the SAFETY PAD(6) from the frame. After the SAFETY PAD(6) is removed, place the
trampoline on the floor with the threaded connectors pointing up. Refer to illustration Step 3.
Threaded
Connector
Bracket Guide
The safety pad must
be removed before
folding the trampoline.
Wire Ring
11
STOP! ALWAYS USE TWO OR MORE STRONG PEOPLE TO UNFOLD OR FOLD THE INTONE
JOGGER TRAMPOLINE. FAILURE TO USE TWO OR MORE STRONG PEOPLE MAY ALLOW THE
RAILS TO SPRING BACK INTO THE FOLDED POSITION AND STRIKE SOMEONE WHICH CAN CAUSE
SERIOUS BODILY INJURY OR DEATH.
STORAGE INSTRUCTIONS
Step 3 Step 4
Step 5 Step 6