Snapper 1300 Series - Manual (Page 13)

Operation
GENERAL
Before operating this rider for the first time, the owner
should operate in an open area without mowing, to
become accustomed to the unit. The left side of the
mower can be used to trim close to objects. Be sure to
read all information in the Safety and Operation sections
before attempting to operate this rider and mower.
Never allow passengers to ride on the unit.
lowing the rider will cause transmission dam-
age. Do not use another vehicle to push or pull
WARNING SLOPE OPERATION
Never operate on slopes greater than 30 percent
(16.7’) which Is a rise of three feet vertically in 10 feet
horlzontally. Select slow ground speed before driving
onto slope. Use extra caution when operating on
slopes with rear-mounted grass catcher. Mow UP and
DOWN the slope, never across the face, use caution
when changing directions and DO NOT START OR
STOP
ON SLOPE.
A
WARNING
To reduce fire hazard, keep the engine and
mower free of grass, leaves and excess grease.
A
WARNING
The Interlock safety switches are for your safety.
Do not attempt to bypass them.
Figure 4. Belt Installation
A. PTO (Electric Clutch) C. Belt Stop
B. Idler Pulley
MOWER INSTALLATION
i s s e a t e d .
Stop engine and remove key Do not engage PTO
until mower is completely installed and operator
Position mower deck directly in front of rider.
2. Route belt underneath rider and over the drive axle.
Install mower belt around bottom pulley (V-side) of
PTO. Refer to figure 4.
3. Connect wire harness for PTO as shown in figure 5.
Secure wire to belt stop with reusable ties. If ties are
damaged, tape wire securely at top and bottom of
belt stop.
NOTE: Perform mower installation on a hard, level sur- 4. Install rod to PTO as shown in figure 6. Insert other
face such as a concrete floor. end through frame and secure with spring clip.
gure 5. PTO Wire Harness
H a r n e s s P l u g C . T i e s
B. Belt Stop
9