Sierra Wireless 350 - Manual (Page 6)

o Welcome
o Installation
o Overview
o Mounting
o Host Cable
o Antenna
o Power Cable
o Using AirBooster
o Troubleshooting
o Service
o Contact Us
User Guide
Installation Overview
This section contains instructions for installing the AirBooster RF amplifier.
Before you can use your AirBooster amplifier for the first time you must:
Mount the AirBooster amplifier in your vehicle. ( more... ) 1.
Install the CDPD device cabling and connector. ( more... ) 2.
Install the antenna, cabling, and connector. ( more... ) 3.
Install and connect the power cable. ( more... ) 4.
Installation of the optional GPS is covered in separate sections on the GPS
generally , the Field Upgrade Kit , and its related software .
o Installation (top)
o Mounting
o
Host Cable
o Antenna
o Power Cable
Mounting the AirBooster RF Amplifier
Your AirBooster RF amplifier is designed for mounting in a vehicle, either in
the trunk or some other suitable location.
Choose a location within the vehicle which:
Allows access to the connectors on the front panel. ❍
Provides access for installing needed connector cables. ❍
Avoids excessive heat from sources such as the engine
compartment, heaters, or vehicle exhaust. ❍
Protects it from weather and excessive moisture. If mounted in
the passenger compartment, ensure that spills cannot leak into
the unit. ❍
1.
Use the mounting template supplied to mark the location of the
mounting holes. 2.
Drill the required pilot holes (5/32"). 3.