Servis-Rhino CY84 - Manual (Page 101)

OPERATION
CY84 03/08 Operation Section 4-13
© 2008 Alamo Group Inc.
OPERA
T
ION
Safety Chains
When towing implements on a public roadway, use a safety chain with tensile strength equal to or greater than
the gross weight of the unit being towed. This will control the implement in the event the hitch pin is lost during
transport.
After the ends of the safety chain are attached to the implement and the tractor, make a trial run by driving the
tractor to the right and to the left to check for proper length. If necessary, readjust the chain to eliminate loose
or tight chain lengths.
7.1 Setting Mower Height - Lift-Type
1. Park the tractor and mower on level ground.
2. Using the 3-point hitch control lever, position
the front of the mower with the side skids 1”
less off the ground than desired cut height. For
example, for a 3” cut, position the skids 2” from
the ground. Set the 3-point control lever stop at
this position to maintain this height when raising
and lowering the mower.
3. Shut down the tractor and remove the key.
4. Level the mower deck front to rear by extending
or retracting the 3-point top link.
5. Level the mower side to side by manipulating
one lower lift arm length. On most tractors, at
least one of the lift arms is designed to allow for
manipulation of its length. Shortening or
extending will allow for deck leveling from side
to side.
6. Securely block up the mower at this height.
7. Remove the bolts securing the tail wheel beam
positioning bracket to the support brackets and
allow the tail wheel to rest at ground level. Align
beam and positioning brackets holes with clos-
est set of holes in support brackets and reinstall
bolts securing the beam in position. Tighten all
bolts and nuts.
7. SETTING THE MOWER
Properly setting the cutting height is essential for efficient and safe operation. A properly set mower will make
a more uniform cut, distribute clippings more evenly, require minimal tractor work, and follow the contour of
uneven terrain. NOTE: Avoid very low cutting heights, striking the ground with the blades gives the most
damaging shock loads and will cause damage to the mower and drive. Blades contacting the ground may
cause objects to be thrown out from under the mower deck. Always avoid operating the mower at a height
which causes the blades to contact the ground. OPS-U- 0010