Sanyo PJLINK PDG-DXL100 - Manual (Page 13)

12
English
Introduction
Remote Control Battery Installation
Open the battery com-
partment lid.
1
Replace the com-
partment lid .
3
Install new batteries into the
compartment.
2
Two AAA size batteries
For correct polarity (+
and –), be sure battery
terminals are in contact
with pins in the com-
partment.
To ensure safe operation, please observe the following precautions :
■ Use two (2) AAA type batteries.
■ Always replace batteries in sets.
■ Do not use a new battery with a used battery.
■ Avoid contact with water or liquid.
■ Do not expose the remote control to moisture or heat.
■ Do not drop the remote control.
■ If the battery has leaked on the remote control, carefully wipe the case clean and
install new batteries.
■ Risk of an explosion if battery is replaced by an incorrect type.
■ Dispose of used batteries according to the instructions.
■ If the new battery are installed into the compartment within 3~4 hours, the remote
control code will not be returned to default.
■ The original setting will be kept and will not be erased.
Remote Control Operating Range
Point the remote control
toward the projector (In-
frared Remote Receiver)
when pressing any button.
Maximum operating range
for the remote control is
about 39.4’ (12m) and 60° in
top of the projector.
39.4’ (12m)
Approx.30°
 Infrared Remote
Receiver is provided
on the top of the pro-
jector.
 Point the remote
control from obliquely
above toward the In-
frared Remote Receiver
when operating the
remote control.
Note