Sony KV-14VM5MT - Manual (Page 35)

EN
Additional Information 35
Possible causes and remedies
•
The AC power cord is disconnected.
/
Connect the AC power cord.
•
The video TV is switched off.
/
Press POWER on the video TV. If the STANDBY lamp is
lit in red, press POWER or a program number on the
Remote Commander.
•
An earphone is connected to @ jack.
/
Disconnect the earphone.
•
"MUTING" is displayed on the screen.
/
Press MUTING.
•
Press VOL +/–.
•
Adjust “PICTURE,” “COLOR,” and “BRIGHTNESS” in the
PICTURE CONTROL menu. (page 18)
•
Press PICTURE MODE to switch the picture setting. (page 17)
•
The connecting cord between the video TV and the input
source is disconnected.
/
Connect it firmly.
•
Input is not selected correctly.
/
Press INPUT SELECT so that “LINE” appears. (page 18)
•
The TV broadcast system is not selected correctly.
/ Check the system referring to the table on page 39 and
preset the channel manually.
•
The power has been interrupted or the AC power cord is
disconnected.
/
Re-set the clock and timer settings. (pages 15, 25)
•
The safety device has been activated.
/
Switch off, disconnect the AC power cord, and leave the
set for about one minute.
•
The color system is not set correctly.
/
Set “COL SYS” to the setting corresponding to the color
system that the tape is recorded in. (page 20)
•
Adjust the tracking. (page 33)
•
The video heads are dirty.
/
Clean the heads using the Sony V-25CL video head cleaning
tape (page 37). If the cleaning tape is not available in your
area, have the heads cleaned at your nearest Sony service
facility. (Do not use a commercially available wet-type
cleaning tape, as it may damage the video heads.)
•
The tape is worn out.
/
Use a new tape.
•
The tape is defective.
/
Use a new tape.
Additional Information
Troubleshooting
Function
TV reception
Problems
No picture (screen is dark),
no sound
Good picture but no sound
No color or poor color
(screen is dark) for color
programs, but good sound
No picture, no sound from
video input source
A receivable channel in your
area cannot be received or
the sound of the received
channel is distorted.
The clock has stopped and
“--:--” is displayed.
Power is on, but the tape
does not run.
Poor playback picture
The sound drops out.
Playback
Clock and
timer