Samsung SCC-C4339P - Manual (Page 24)

24_ setup
setup
FOCUS MODE
You can select a focus mode according to the
angle that you adjusted for camera recording.
- AF : This will monitor the screen continuously
to focus automatically. If you adjust the focus
manually, that will operate the same as in
<MF>. This will also restore focus after the
operation of zoom.
- ONEAF : Restores focus after the operation
of zoom, and operates the same as in <MF>
unless the operation of zoom is executed.
- MF : You can adjust the focus manually.
While you are working on the following objects, <AF> may not work properly.
If this is the case, use <MF> instead.
- Very bright object, or dominant object in a dark scene
- Object against the rear side of a moist or dirty glass
- A scene where nearby and distant objects co-exist
- White wall or single-colored object
- Venetian blinds and other horizontally striped objects
ZOOM SPEED
You can adjust the zoom operation speed.
DISPLAY ZOOM
You can set to display the zoom status on the screen.
It will disappear in about 3 seconds if the zoom factor has no further change.
DIGITAL ZOOM
You can set the maximum allowable digital zoom ratio.
Digital Zoom will start operation after it is zoomed in to the maximum optical ratio of
x34. If you set DIGITAL ZOOM to x16, you can take a shot at up to x544 (34x16).
When you set DISPLAY ZOOM as on, you may see zoom value on the screen.
DETAIL
Used to adjust the vertical and horizontal distinction, respectively.
M 

DAY/NIGHT AUTO DAY/NIGHT AUTO
WHITE BAL
WHITE BAL
FOCUS MODE ONEAF
ZOOM SPEED ZOOM SPEED [2] [2]
DISPLAY ZOOM OFF DISPLAY ZOOM OFF
DIGITAL ZOOM X16 DIGITAL ZOOM X16
DETAIL [2] DETAIL [2]
V-SYNC
INT V-SYNC INT
AGC COLOR SUP
MID AGC COLOR SUP MID
SCC-C4239P-TRK-ENG.indd 24 SCC-C4239P-TRK-ENG.indd 24 2009-10-9 9:31:48 2009-10-9 9:31:48