Swann OutdoorCam SW244-AUO User Manual
Page 3
1.
2.
3.
4.
5.
Once you have chosen the best position for the camera, switch the power to the
camera off, and unplug the power lead from the camera.
When mounting the Outdoorcam camera to your ceiling or wall, please ensure that
you rotate the camera so that at the top of the camera lens is ‘up’, otherwise you will
find that your pictures are displayed upside down. (see diagram)
Hold the camera base in the position you wish to fix it, and mark the holes with an
appropriate pen or pencil. Once this is done, remove the stand and drill a hole with
the appropriate drill bit for the material you are mounting your camera to and the
screws or fasteners you are using.
Run the camera cable back to the TV/VCR, any holes that you drill need to be at least
/ ” (14mm) in diameter to allow the connectors to pass through.
Reconnect the power lead to the camera and switch the camera power back on.
9
16
6. Position the camera and firmly lock the stand into place. Do not over tighten or
forcefully adjust the camera once it has been correctly positioned.
Step 1:
Step 2:
yellow
"Video In"
Step 3:
black
black
power adaptor
Step 4:
power adaptor
Step 5:
A/V TV
TV
AV
TV
VCR
VCR
A/V Input
TV
VCR
Note:
Note:
instructions
VCR
TV
A/V inputs.
At the end of your Outdoorcam camera cable you will find two colored plugs:
•Yellow (Video RCA)
•Black (DC Power)
Plug the
RCA plug (1) into the
input (2) (usually located at the back of your TV
or VCR).
Connect the
plug (3) at the end of your Outdoorcam camera into the
plug at the end
of the
(4).
Plug the
(5) into the mains power point in your wall.
If you have an
with RCA sockets you will need to switch the
to the
channel on
your
to view the camera. To connect the Outdoorcam camera to your
, you will need to
turn the
to the
selection and turn your
onto the channel you would normally
use to view a tape or movie on your
. This channel may be activated by a button on your
remote that is marked with this symbol
, or
or
or possibly
or
.
The Outdoorcam will automatically turn on the Infra-Red LEDs when available light is too low to
support a clear picture.
Please read the
for your
or
for more information on using their
L
L2
AV
AV2
1
1
How to connect Outdoorcam camera to your TV or VCR
Mounting the camera on your wall or ceiling
3
Outdoorcam kameran är konstruerad för användning med vilken som helst TV, VCR, bevakningsmonitor
eller dator med “video capture”- kort. Kameran har en synlig bild och den kan användas inomhus och
utomhus under skydd. Outdoorcam kameran kan användas för ett antal olika ändamål såsom bevakning av
besökare vid ytterdörr, parkeringsplats och bil, affärsutrymmen eller som babymonitor.
1. Kamera med stativ och 18m/60ft kabel
9Volt DC 300mA Nätadapter (adaptermodellen varierar beroende på land)
2.
1
2
Din Outdoorcam kamera med nätdrift är konstruerad för att sända svartvita bilder med hög kvalitet till din TV.
För att vägleda dig genom installationsprocessen av din Outdoorcam kamera, har vi lagt upp olika steg och
numrerat komponenterna i diagrammet nedan.
* För att förlänga räckvidden mellan kameran och din TV eller VCR, behövs en förlängningskabel (ingår ej ), som finns tillgänglig hos
flesta radiohandlare eller elektronik affärer.
Note: We do not recommend extending the cable length past
100 metres with a single cable run to avoid loss of signal.
Multiple cable sections connected to make up one cable length will drastically reduce the video signal run distance.
330 Feet/
GUL
VCR, TV eller MONITOR
OUT
IN
VIDEO
VIDEO
AUDIO
AUDIO
VIDEO IN
2
SVART
3
4
1
KAMERA
NÄTADAPTER
5
Installationsföreskrifter
Bipackade tillbehör
Anslutning av Outdoorcam kameran till din TV eller VCR
14
SPÄNNINGSKONTAKT