Stellar Industries TELESCOPIC CRANE EC2000 - Manual (Page 12)

8 EC2000 Owner’s Manual
Item Part No. Description QTY
01 18040 DECAL IDENTIFICATION EC2K 2
02 18039 DECAL CAPACITY EC2K 2
03 4214 DECAL CONTACT STELLAR 1
04 6727 DECAL DANGER ELECTROCUTION VERT 1
05 C4540 DECAL DANGER 1
06 4190 DECAL DANGER OPERATION CONDITION 1
07 4189 DECAL DANGER OPERATION RESTRICTION 1
08 C4544 DECAL CAUTION 1
EC EC
2000 2000 1804 0 18040
EC EC
2000 2000
18040 18040
PN 18776
Decals of Note
DANGER
• Main safe clearances from electrical lines. This crane
does not provide protection from contact with or proximity to
an electrically charged conductor. Allow for boom, electrical
line and load line swaying.
• Maintain a clearance of at least 10 feet between any part of
the crane, load line or load and any electrical line carrying
up to 50,000 volts.
• One foot additional clearance is required for every additional
30,000 volts or less.
ELECTROCUTION HAZARD
THIS CRANE IS NOT INSULATED
DEATH OR SERIOUS INJURY
WILL RESULT FROM CONTACT
OR INADEQUATE CLEARANCE
6727
DANGER
FAILURE TO OBEY THE FOLLOWING
WILL RESULT IN
INSTABILITY OR
STRUCTURAL DAMAGE
• Read, understand and follow the equipment
load and work area charts.
• Do not exceed winch or equipment ratings.
• Do not exceed jib load ratings at reduced
boom lengths.
• Weights of accessories attached to the
boom or loadline must be deducted from
the load chart ratings or be added to the
load weight.
4189
DEATH OR SERIOUS INJURY
DANGER
AN UNTRAINED OPERATOR
SUBJECTS HIMSELF AND
OTHERS TO
YOU MUST NOT OPERATE
THIS EQUIPMENT UNLESS
• You have been trained in the safe
operation of this equipment.
• You read, understand and follow the
safety and operating recommendations
contained in the equipment manufacturer’s
manuals, your employer’s work rules and
applicable government regulations.
C4540
DEATH OR SERIOUS INJURY
DANGER
FAILURE TO OBEY THE FOLLOWING
WILL RESULT IN
• Inspect equipment and its operation daily.
• For equipment stability, use only on solid,
level surface with outriggers properly
extended.
• Equipment must be level.
• Operate all controls slowly and smoothly.
• Never operate the equipment with
personnel under boom or load.
• Keep load underboom tip. Do not side
load boom or drag loads. Avoid free
swinging loads.
• Keep at least 3 wraps of loadline on
winch drum.
• For travel, boom and outriggers must be
in stowed position.
C4544
DEATH OR SERIOUS INJURY
DANGER
FAILURE TO OBEY THE FOLLOWING
WILL RESULT IN
• Follow all recommended inspections and
maintenance practices listed in the equipment
manufacturer’s manuals. If manuals are
missing from this equipment, contact
manufacturer for replacement.
• Do not modify or alter this equipment without
written manufacturers approval. Use only
manufacturer approved attachments or parts
on this equiupment.
• Equipment must be mounted on factory
recommended chassis. If re-mounted or
rebuilt, the equipment must be re-certified.
4190
DEATH OR SERIOUS INJURY
Decal Kit - PN 18776