Sanyo CLT-J30 - Manual (Page 29)

29
TECHNICAL INFORMATION
CHARGE/IN USE LED ON BASE KEEPS FLASHING
•
Provided your phone company offers voice mail indicator service
and you subscribe to it, the CHARGE/IN USE LED flashes when
the phone is in use to indicate there is a message waiting. It stops
flashing after the message has been reviewed.
Causes of poor reception
•
Aluminum siding.
•
Foil backing on insulation.
•
Heating ducts and other metal construction can shield radio signals.
•
You are too close to appliances such as microwaves, stoves,
computers, etc.
•
Atmospheric conditions, such as strong storms.
•
Base is installed in the basement or lower floor of the house.
•
Base is plugged into an AC outlet with other electronic devices.
•
Baby monitor is using the same frequency.
•
Handset battery is low.
•
You are out of range of the base.
To keep your telephone working and looking good, follow these
guidelines:
•
Avoid putting the phone near heating appliances and devices that
generate electrical noise (for example, motors or fluorescent lamps).
•
Do not expose to direct sunlight or moisture.
•
Avoid dropping the phone, and other rough treatment to the phone.
•
Clean the phone with a soft cloth.
•
Never use a strong cleaning agent or abrasive powder because this
will damage the finish.
•
Periodically clean the charge contacts on the handset and base with
a clean pencil eraser.
•
Retain the original packaging in case you need to ship the phone at a
later date.
TROUBLESHOOTING
MAINTENANCE