Sanyo VCC-WB2000 - Manual (Page 24)

Network Camera Settings
1 AUTHENTICATION
This sets the verification protocol to be use
when connecting to the access point. Set this to
the protocol specified by the Internet Service
Provider. It should normally be set to “AUTO”.
Available settings:
•
AUTO: PAP or CHAP is chosen
automatically as required
•
PAP: Only PAP verification is used.
•
CHAP: Only CHAP verification is used.
2 CIRCUIT TYPE
This sets the type of telephone circuit that the
modem is connecting to.
Available settings:
•
TONE: For tone dialing circuits
•
PULSE: For pulse dialing circuits
Note: Set to “TONE” if using a terminal adapter.
3 BAUD RATE
This sets the communication speed for the
modem.
Available settings: 115200, 38400 (bps)
4 DATA SIZE
Available settings: 8, 7 (bits)
5 PARITY
This sets the parity.
Available settings:
•
NONE: No parity
•
EVEN: Even parity
•
ODD: Odd parity
6 STOP BIT
Available settings: 1, 1.5, 2
7 AUTO IP ADDRESS display
This shows the IP address for the camera.
Note: This is only displayed while the camera is
connected.
8 ERROR INFO. display
This shows error information relating to the
previous PPP connection.
Display details:
•
Modem timeout or Not connected
•
Line connection error
•
Line disconnected
•
PPP connection error
•
PPP verification error
•
PPP connected and disconnected normally
L5AB2/US (VCC-WB2000) GB 2002, 7, 4
English – 23 –