Swim'n Play oval 4ft pool - Manual (Page 17)

17
EZ HOOK LINER INSTALLATION
ATTENTION: An 8 inch cove must be placed all around the inside of the pool
1. Clear all sticks and sharp objects from an area near the pool,
that is as large as the pool itself. Remove the liner from its
carton and unfold and open the liner. Refold the liner so that
it can easily be carried to the pool and unfold from the outside
of the pool. Check the levelness of the sand in the pool and
make sure that no sharp objects are still in the pool.
2. Place the liner into the pool while holding onto the top of the
wall section of the liner.
3. Place the EZ Hook of the liner onto the top of the wall around the
entire pool. Temporarily place a few of the top rails over the liner
edging to support and sturdy the wall. Continue in this manner
around the entire pool.
4. Gently pull on the liner and use a soft bristle broom to remove
as many wrinkles as possible on the bottom of the pool.
5. Start filling the pool slowly with water. Continue pulling gently
and working the liner with a broom as needed.
6. Some wrinkling of the liner may be evident and in no way
affects the structural strength of your pool. Once the water
is filled to a point that the liner is pressed firmly against the
wall install the thru-the-wall skimmer following its instructions.
Then you can fill the entire pool as quickly as desired.
EZ HOOK
VINYL LINER
TOP RAIL
POOL WALL
OUTSIDE VIEW
OF POOL WALL
COVE
8”
8”
OPTIONAL
WALL
GUARD
12”
12”
BEADED LINER INSTALLATION
1. Clear all sticks and sharp objects from an area near the pool, that is as large
as the pool itself. Remove the liner from its carton and unfold and open the
liner. Refold the liner so that it can easily be carried to the pool and unfold
from the outside of the pool. Check the levelness of the sand in the pool
and make sure that no sharp objects are still in the pool.
2. Install the bead receiver onto the top of the pool wall. Temporarily place
a few of the top rails over the bead receiver to support and sturdy the wall.
3. Place the liner into the pool while holding onto the top of the wall section of
the liner.
4. Snap the bead of the liner into the bead receiver around the entire pool.
5. Gently pull on the liner and use a soft bristle broom to remove as many wrinkles as possible on the
bottom of the pool.
6. Start filling the pool slowly with water. Continue pulling gently and working the liner with a broom as
needed.
7. Some wrinkling of the liner may be evident and in no way affects the structural strength of your pool.
Once the water is filled to a point that the liner is pressed firmly against the wall install the thru-the-wall
skimmer following its instructions. Then you can fill the entire pool as quickly as desired.