Smeg PU64 User Manual
Smeg Hobs
Table of Contents
1. IMPORTANT SAFETY INSTRUCTIONS ................................................................................. 4
2. COOKTOP MEASUREMENTS ............................................................................................... 5
3. POSITIONING THE COOKTOP AND LOCATION REQUIREMENTS .................................... 6
3.1 Gas supply requirements ................................................................................................................................ 8
3.2 Electrical requirements .................................................................................................................................... 9
4. INSTALLING THE COOKTOP ............................................................................................... 11
5. CHECKING OPERATION ...................................................................................................... 14
6. WIRING DIAGRAMS ............................................................................................................. 15
INSTRUCTIONS FOR THE INSTALLER: these are intended for the qualified engineer who is able to
install, commission and test the appliance
3
Document Outline
- Important safety instructions
- 2. COOKTOP MEASUREMENTS
- 3. POSITIONING THE COOKTOP AND LOCATION REQUIREMENTS
- 1 Remove all packaging parts (e.g. crate, carton, polystyrene and metal hooks). Do not eliminate this manual as it is an integral part of the appliance and it should be kept handy for easy reference whenever needed.
- 2 Temporarily remove all removable parts from the cooktop that could fall and cause personal injury or damage to objects (burners, crowns and flame caps) during the attachment procedures These parts must be refitted before using the appliance.
- 3.1 Gas supply requirements
- 3.2 Electrical requirements
- 3.2.1 Recommended Grounding Method
- 4. INSTALLING THE COOKTOP
- 5. CHECKING OPERATION
- 1 Fit the crowns, ensuring that they are perfectly locked into their housing on the cooktop.
- 2 Fit the flame caps on the crowns, ensuring that the edges match perfectly.
- 3 Fit the grids, making sure to fasten the side spokes in the special “A” seats found on the cooktop.
- 1 a spark must light on all burners when the knobs on the top are pressed
- 2 when each knob on the cooktop is pressed and turned to the min flame symbol ( ), the entire crown should light.
- 3 lf burners do not light properly, turn the control knob to the "OFF" position . Check that burner caps and crowns are in the p...
- 6. WIRING DIAGRAMS