Woodstock D2796 - Manual (Page 9)

- 7 - Woodstock Intl., Inc. D2796
ADJUSTMENTS
1. The hand levers clamp your workpiece in place.
2. The fence knobs hold the fence in place. Loosen
these knobs to adjust fence position.
3. The upper side stops align the workpiece hori-
zontally under the template.
4. The front side stops align the vertical workpiece
to the horizontal workpiece.
5. The template knobs hold the template in place.
Loosen these knobs to adjust template position.
6. The clamping pressure knobs control the height
of the clamping bar and adjust cam clamping pres-
sure.
Hand Lever
Fence Knob
Clamping Pressure Knob
Template Knob
Hand Lever
Clamping Pressure Knob
Figure 7 shows the adjustment locations for the dovetail jig.
Upper Side Stops
Front Side Stops
ADJUSTMENT LOCATIONS
NOTICE
When describing adjustments and operations in
this manual, reference is made to the pieces being
joined as fronts, backs or sides. These pieces indi-
cate drawer fronts, backs, and sides. Front and
back pieces mount horizontally on top of the jig
and side pieces mount vertically in the front of the
jig. The insides of the boards always face out!