Sharp DT-500 - Manual (Page 38)

Basic
Operation
37
: Cutout area on which images cannot be projected.
Computer
Input Signal
STRETCH
Output screen image
Computer
Image
type
SIDE BAR
1280K720
Resolution lower than
XGA
XGA
(1024K768)
4:3 aspect
ratio
16:9 aspect
ratio
CINEMA
ZOOM
DOT BY DOT
4:3 aspect
ratio
About Copyrights
• When using the RESIZE function to select an image size with a different aspect ratio
to a TV program or video image, the image will look different from its original appear-
ance. Keep this in mind while choosing an image size.
• The use of the Resize, Keystone Correction, Subtitle, or Overscan function to com-
press or stretch the image for commercial purposes/public displays in a café, hotel,
etc. may be an infringement of copyright protected by law for copyright holders. Please
use caution.
• While watching non-widescreen images (4:3), if you use the RESIZE function to fill
the screen or use the Overscan function to change the aspect ratio of a fixed-ratio
input signal, parts of the outer edge of the image will be cut off or distorted. To watch
original images as the producers intended, set RESIZE to “SIDE BAR” and Overscan
to its default setting.
• You can select “CINEMA ZOOM” when with a “VGA/SVGA” signal with a vertical frequency 60 Hz and
less. However, when a “VGA/SVGA” signal with a vertical frequency of more than 60 Hz is used,
“CINEMA ZOOM” is not available.
Note
DT-500_EN_h 06.2.16, 10:00 AM 37