Sony CDX-M7810 - Manual (Page 9)

9
CDX-M7815X/M7810
2-586-657-11 (1)
H:\Data Disk\2586657111\258665711CDXF7815XU\01US02CD-U.fm masterpage:Right H:\Data Disk\2586657111\258665711CDXF7815XU\01US02CD-U.fm masterpage:Right
Tuning automatically
1 Select the band, then press (ENTER)
repeatedly until “SEEK” appears, then
rotate the SEEK control dial to search
for the station.
Scanning stops when the unit receives a
station. Repeat this procedure until the
desired station is received.
Tip
If you know the frequency of the station you want to
listen to, press
(ENTER) repeatedly until “MANUAL”
appears, then rotate the SEEK control dial until the
desired frequency appears.
Receiving a station through a list
— LIST
You can list up the frequency or the name. For
details on labeling a station, see page 10.
1 Select the band, then press (MENU) .
2 Rotate the SEEK control dial until
“List” appears, then press
(ENTER) .
The frequency or station name appears.
3 Rotate the SEEK dial until the desired
station appears.
4 Press (ENTER) to receive the station.
The display returns to normal reception
mode.
With the card remote commander
Select the band, then press
(LIST) . Press M or m
repeatedly until the desired station appears, then
press
(ENTER) .
Other functions
Changing the sound settings
Adjusting the sound
characteristics
You can adjust the equalizer, DSO, bass, treble,
balance, fader and subwoofer volume.
1 Select a source, then press (SOUND)
repeatedly to select the desired item.
The item changes as follows:
EQ7 t DSO t BAS (bass) t
TRE (treble) t BAL (left-right) t
FAD (front-rear) t SUB (subwoofer
volume)*
* “
∞
” is displayed at the lowest setting, and can be
adjusted up to 20 steps.
2 Rotate the VOL control dial repeatedly
to adjust the selected item.
After 3 seconds, the setting is complete and
the display returns to normal play/reception
mode.
Note
Adjust within 3 seconds of selecting the item.
With the card remote commander
In step 2: press
< or , instead of the VOL control
dial.
Adjusting the equalizer curve
— EQ7 Tune
You can adjust and store the equalizer settings
for different tone ranges.
1 Select a source, then press (MENU) .
2 Rotate the SEEK control dial until
“Sound” appears, then press
(ENTER) .
3 Rotate the SEEK control dial until
“EQ7 Tune” appears, then press
(ENTER) .
4 Rotate the SEEK control dial to select
the desired equalizer type, then press
(ENTER) .
5 Rotate the SEEK control dial to adjust
the desired volume level.
The volume level is adjustable in 1 dB steps,
from –10 dB to +10 dB.
continue to next page t