Kambrook Caf 3 in 1 Coffee Maker KDC120 User Manual

Page 3

Advertising
background image

OPERATING YOUR
KAMBROOK CAFÉ
3 IN 1 COFFEE MAKER

The 3 in 1 functions of the Café coffee
maker can be selected using the two
separate control mechanisms on the front
of the appliance:

FILTERED COFFEE
ESPRESSO COFFEE

Individual Espresso coffee can be brewed,
then the milk frothed whilst the Filtered
coffee drips into a large 10-cup carafe.

1) HOW TO MAKE AN ESPRESSO
Filling the Espresso water tank

Switch the power off at the power
outlet and unplug the power cord.

Ensure the Espresso/Steam Selector
Control is in the ‘STANDBY’ position.

Ensure any steam pressure in the
appliance has been released each time
BEFORE re-filling with cold water.

Lift the lid of the Espresso water tank
and unscrew the water tank cap. Pour
cold water into the tank. Fill to 5mm
below the visible water pipes. Do not
fill to the top of the tank or there will
not be enough space to generate steam.

Screw the water tank cap back on top of
the water tank, making sure it is secured
firmly before operating the appliance.
Close the Espresso water tank lid.

NOTE: Do not use warm or hot water or any other
liquid to fill the water tank.

DO NOT POUR WATER INTO

THE ESPRESSO WATER TANK
WHILE THE ESPRESSO/STEAM
SELECTOR CONTROL IS IN THE
ESPRESSO OR STEAM POSITION.

Preparing the ground coffee for
Espresso

Remove the Espresso filter holder by
rotating it 45 degrees to the left.

Place the stainless steel filter into the
Espresso filter holder and use the
measuring spoon to fill the filter with
ground espresso coffee to the required
cup level marking inside the filter. Do
not fill above the 4 cup mark. Distribute
the ground coffee evenly in the filter
and press it lightly with the bottom
end of the measuring spoon.Too much
coffee can block the flow of water,
similarly, do not press the coffee heavily
as this can block the flow of water.

Remove any excess ground coffee from
the rim of the Espresso filter holder to
ensure a proper fit under the brew head.

IMPORTANT SAFEGUARDS
FOR ALL ELECTRICAL
APPLIANCES

Unwind the cord before use.

Do not let the cord hang over the edge
of a table or counter, touch hot surfaces
or become knotted.

The appliance is not intended for use by
children or infirm persons without
supervision.

Children should be supervised to ensure
that they do not play with the appliance.

It is recommended to regularly inspect
the appliance. Do not use the appliance
if power supply cord, plug or appliance
becomes damaged in any way. Return the
entire appliance to the nearest authorised
Kambrook Service Centre for
examination and/or repair.

Any maintenance other than cleaning
should be performed at an authorised
Kambrook Service Centre.

This appliance is for household use only.
Do not use this appliance for anything other
than its intended use. Do not use in moving
vehicles or boats. Do not use outdoors.

The installation of a residual current
device (safety switch) is recommended to
provide additional safety protection when
using electrical appliances. It is advisable
that a safety switch with a rated residual
operating current not exceeding 30mA be
installed in the electrical circuit supplying
the appliance. See your electrician for
professional advice.

BEFORE USING YOUR 3 IN 1
COFFEE MAKER

Wash the Espresso filter holder, Espresso
stainless filter, Drip filter basket holder,
permanent mesh filter basket and carafes
in mild detergent and warm water. Rinse
and dry thoroughly.

It is recommended to carry out a complete
brewing operation with cold water but
without any coffee before making your
first Espresso, Cappuccino (see How to
make an Espresso) or Drip Filter Coffee
(see How to make Drip Filter Coffee).
This will remove any residual dust from
the Café 3 in 1 coffee maker.

4

5

Advertising