Kompernass KH4077-11/07-V1 - Manual (Page 9)

- 3 -
Description of the appliance
q ON/OFF Switch
w Floodlight lever
e Halogen floodlight
r Protective grill
t Knurled screw
y Crossbeam
u Telescopic stand
i Power cable
o Knurled screw
a Fixing ring
s Distributor box
d Knurled screw
f Fixing screw
g Glass cover
Assembly
ƽ
Danger of electrical shock
Never insert the plug into an electrical socket until
the appliance has been completely assembled.
ƽ
Danger of burns
Only touch the halogen lamps when they are in a
switched-off and cooled-down condition. The halo-
gen lamps will get very hot. Never touch the light-
bulb with bare hands, always use a clean and dry
lint-free cloth.
Opening up the pedestal base
➩ To set up the telescopic stand u , loosen the
knurled screw, o . The pedestal base can now
be opened out to the floor.
➩ Turn the knurled screw o until it is tight.
Assemble the protective grill r on to
the halogen spotlights e
➩ Insert the lower pegs of the protective grill r
into the recesses on the corners before the glass
covering
g .
➩ Squeeze the protective grill r so far together
that the pegs on the other side of the protective
grill can be inserted into the recesses there.
➩ Do the same with the second halogen spotlight
Mounting the halogen floodlights e
on the crossbeam.
➩ Insert the knurled screw t with the washer
through the hole in the bracket of the halogen
floodlight
e .
➩ Insert the halogen floodlight e with the knurled
screw t in the pre-drilled hole on the crossbe-
am y . Ensure that the Stoppers are located be-
hind the halogen floodlights e .
➩ Turn the knurled screw t until it is tight.
Assembling the crossbeam on the
telescopic stand.
➩ Insert the knurled screw d first of all through the
hole in the distributer box s , then through the
hole in the crossbeam y .
➩ Now assemble the crossbeam y and the distri-
butor box s with the assistance of the knurled
screw d on the telescopic stand u .
➩ Turn the knurled screw d until it is tight.
Adjusting the height of the Stand
Halogen Floodlight
➩ Loosen the fixing ring a by turning it in an
anti-clockwise direction.
➩ Adjust the telescopic stand u to the desired
height.
➩ Retighten the fixing ring a by turning it in a clok-
kwise direction.
IB_KH4077_BK1968_LB6 30.11.2007 14:47 Uhr Seite 3