Knoll Systems HD282 - Manual (Page 26)

26
7. Tighten the single screw.
8. Replace the lamp door by sliding the tabs into the tab bays and tightening the two screws.
9. Plug in the power cable, then press the Power button to turn the projector back on.
10. Reset the lamp hour timer.
Resetting the lamp timer
To reset the lamp age, simultaneously holding down the two Brightness buttons on the projector’s keypad
for 10 seconds.
Using the security lock
The projector has a security lock for use with a PC Guardian Cable Lock System. This lock needs to be
order from Knöll Systems. Refer to the information that comes with the lock for instructions on how to use it.
Specifications
Temperature Operating
50 to 95 ° F (10 to 35° C) at 0 - 10,000 feet
Non-operating -4 to 158 ° F (-20 to 70° C) at 0 -20,000 feet
Altitude Operating
0 to 10,000 feet (3,048 meters)
Non-operating 0 to 20,000 feet (6,096 meters)
Humidity Operating
10 percent to 95 percent relative humidity, non-condensing
Non-operating 10 percent to 95 percent relative humidity, non-condensing
Dimensions
13.8 x 12.8 x 4.3” (351W x 325L x 110H mm)
Weight
9.3 lbs. (4.24 kg) unpacked
Optics Focus Range
5 - 32.8 feet (1.5 – 10 meters)
Lamp Type
UHP lamp (dual watt: 200 and 250 watt)
Model SP-Lamp-006
Input power requirements
100V-120V 4A 50/60 Hz
200V-240V 2A 50Hz