Kicker ZX200.2 - Manual (Page 3)

3
Model External Fuse Power/Ground Wire KICKER Wiring Kit
ZX200.2 1 x 30 Ampere 8 Gauge PK8, CK8, ZCK8
ZX450.2 1 x 60 Ampere 4 Gauge PK4, CK4, ZCK4
on the source unit and connect the wire to the RCA Inputs on the end panel of the amplifi er or simplify the
installation by using a KICKER ZISL as shown below. Either input method will provide a low-level output signal
at the RCA output, which effectively passes the audio signal to another amplifi er or component. Keep the audio
signal cable away from factory wiring harnesses and other power wiring. If you need to cross this wiring, cross it
at a 90 degree angle.
source unit
high-level speaker
outputs
to amplifi er
shield
+
–
core conductor
GND REM +12V
12V
battery
external fuse
remote turn-on
(see page 5)
bare-metal
chassis ground
18”
(45cm)
24”
(60cm)
SPKR + SPKR - SPKR + SPKR -
L+ L– R+ R–
L L R R
signal in signal out
STEREO OPERATION
minimum impedance of 2 ohms per channel
Install a fuse within 18” (45cm) of the battery and in-line with the power cable connected to your amplifi er. If you
ever need to remove the amplifi er from the vehicle after it has been installed, the ground wire should be the last
wire disconnected from the amplifi er--just the opposite as when you installed it.
KICKER ZISL
source unit high-level
speaker outputs
OR
to amplifi er
protection LED
2010 ZX 200.2 450.2 RevD.indd 3 2010 ZX 200.2 450.2 RevD.indd 3 9/15/2009 4:44:18 PM 9/15/2009 4:44:18 PM