Kohler Bath Whirlpool K-1418-CT - Manual (Page 5)

Lighted User Keypad
Available modes will be illuminated in blue. Active modes will be illuminated in green.
Power
Turns the whirlpool pump on and off. Icons illuminated in blue indicate available
modes/features. Modes which are operating will be illuminated in green.
Outer Ring Rotate the outer ring to the desired mode. The selected mode will flash blue.
OK Activates the desired mode.
Up Arrow Increases the water flow when the Flexjet flow mode is active.
Indicator Bar Displays the water flow volume in the Flexjet flow mode.
Effervescence
Mode Ports activate to provide a gentle, soothing bubbling action.
Down Arrow Decreases the water flow when the Flexjet flow mode is active.
Chromatherapy
Cycle Chromatherapy lights will automatically and continuously cycle through the eight colors:
white, violet, indigo blue, aqua blue, green, yellow, orange, and red. One cycle through all
eight colors takes approximately one minute.
Heater Automatically engages when the power icon is selected. Rotate the outer ring until the
heater mode is flashing, then press OK to turn the heater off. Press OK again to turn the
heater back on.
Chromatherapy -
Specific Color Press OK to activate, then use the up or down arrow to reach the desired color. Press OK
while the chromatherapy cycle is active to turn off the chromatherapy lights.
Operation
NOTE: If the whirlpool is not operating properly, consult the ″Troubleshooting″ section of this guide
before calling a qualified service representative.
Whirlpool
NOTICE: Do not allow the water temperature in the whirlpool to exceed 104°F (40°C). The heater will
automatically maintain the water temperature when the whirlpool is running, as long as the water
temperature does not exceed 104°F (40°C). The heater will disengage at higher temperatures.
Close the drain, then fill the whirlpool to a level at least 2 ″ (5.1 cm) above the highest effervescent
port. Using your hand, test the water temperature for comfort and safety. Carefully enter the bath.
Press the power icon to turn on the whirlpool pump and heater. Water will flow at medium volume.
Press the up or down arrow icons to increase or decrease the water flow. The indicator bar will
display the water flow volume.
If desired, turn the heater off by pressing the heater icon. Press the button a second time to turn the
heater back on.
Chromatherapy Cycle
Heater On/Off
Decreases Flow or Pulse
Effervescence Mode
Increases Flow or Pulse
Rotate outer ring to
access desired mode.
Power On/Off
Chromatherapy - Specific Color
Activates Mode Selected
Indicator Bar
Kohler Co. 5 1023246-5-C